Jump to content

Remote Flash

jedbest
 Share

Recommended Posts

jedbest Rookie

jedbest

Posted
Posted

I am inneed of some advise. I have both the xt2 and xpro2 and wish to get a flash sysrem. Which does this group feel is the best match; Godox AD200, Nissin or the Fuji x500. Thank everyone for your consideration.

 

Jed Best

Link to post
Share on other sites
nathan.mardin Apprentice

nathan.mardin

Posted
Posted (edited)

I am inneed of some advise. I have both the xt2 and xpro2 and wish to get a flash sysrem. Which does this group feel is the best match; Godox AD200, Nissin or the Fuji x500. Thank everyone for your consideration.

 

Jed Best

Depends on the features you're looking for. I'm not familiar with any of those flashes or what they offer. I use the Yongnuo YN-560 IV with the X-Pro2 and they're great. All manual, simple. Edited by nathan.mardin
Link to post
Share on other sites
RM_Photog Contributor

RM_Photog

Posted
Posted

I prefer the godox system. For Fuji, it's all manual flash like the yongnuo, but they have a much more comprehensive flash system that all works together. Godox also recently announced they will be supporting Fuji TTL in the very near future. My favorite part about the Godox system are the Li-Ion batteries! 

Link to post
Share on other sites
  • 1 month later...
RickUrb Rookie

RickUrb

Posted
Posted (edited)

I'm using the Nissin i60 and it works great. Also use the air1 commander. Great build, and it's simplicity in control layout is refreshing.

All that being said, the Goddox looks really good. I may have gone that route if they had TTL

Take a look at Cheetah Stand. They carry Goddox

http://www.cheetahstand.com/

Edited by RickUrb
Link to post
Share on other sites
  • 10 months later...
Guest Him

Guest Him

Posted
Posted

The AD200 Godox is brilliant. Does HSS/TLL and is just fine with slower shutter speed settings too. I have been testing it in the last few days and I am going to be very happy with this unit, both indoors and outdoors. As someone else said those batteries - at last no more AA batteries. In the studio no cables to trip up over. Outside on a light stand, easy to set up.

 

The trigger though takes a little getting used to but it works.

Link to post
Share on other sites
  • 9 months later...
  • 1 month later...
Ken_Udle Apprentice

Ken_Udle

Posted
Posted (edited)

I recently bought an x-Pro2 and needed to use an off camera flash. I own the EF-20 and borrowed an inexpensive transmitter/receiver trigger set (FlashFire by PhotoFlex), The test button on the transmitter fired the flash but there was no communication with the camera no matter what settings I used. In fact the selector wheel didn't work for flash settings. Then I read someone's post saying change from Electronic Shutter to Mechanical Shutter. This did the trick. The selector wheel worked, I was able to modify the flash settings and more importantly the camera triggered the flash. For some reason I had to experiment with the shutter speed, 125th a sec is where I ended up. I was surprised as there are a lot of posts saying only a few trigger systems will work with X cameras. Just goes to show you never can tell. 

 

Edited by Ken_Udle
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Similar Content

  • Posts

    • Neil Rosenberg
      Infrared Photography on X-E2 665nm

      By Neil Rosenberg · Posted

      I'm not exaggerating when I say that I have searched with great vigor (and at great expense) for a way to capture IR images with a Fujifilm camera for which I didn't have to use major amounts of sharpening to bring out the best. Zooms, primes, Fuji, Tamron, Viltrox, Sigma, Zeiss ... probably 20 lenses all told. Plus multiple IR converted Fuji cameras, X-T1, X-T3, X-T5. I even tried different ways of filtering IR, such as using the Kolari clip-ins and lens-mounted front filters. I was ready to give up until I almost accidentally tried one of the cheapest lenses out there -- the little TTArtisan 27mm F2.8. No hotspots that I could see, and best of all ABSOLUTELY SUPERB SHARPNESS across the entire frame. It's this attribute that I search for, and until now, never achieved. In my prior attempts, I listened to the advice from the "pundits", picking up a copy of the venerable Fuji 14mm F2.8, the Zeiss Touitt 12mm F2.8, Fuji 23 and 35mm F2.0, even the very similar 7Artisans 27mm F2.8, and none of them come even close to the TTArtisan for edge sharpness in infrared. Incidentally, I'm using a Kolari 720nm clip-in filter. Sure the TT has its issues -- vignetting at 2.8, tendency to flare with sunlight nearby, but all in all, this lens is glued to my X-T5 for now. This image was taken hand-held with this lens -- completely unedited!
    • Tschortschli
      Screen is flipped with fan001

      By Tschortschli · Posted

      Hy there When Im using the fan001 on the XH2s and I flip the LCD Screen vertically by 180 degrees then the image flips vertically, what is good but it also flips horizontally. The clean feed on HDMI is not flipping horizontally but its also flipping if the HDMI output info display is on. When I unmount the fan then the image flips only vertically. My firmware is updated to the latest version. Any ideas if there is a fix for that?
    • Neil Rosenberg
      Infrared

      By Neil Rosenberg · Posted

      In reply to the original question, it all depends on what you mean by infrared.  If you mean "see thermal information", then I agree with the comments here.  However, if you mean near-infrared, the X-T4, or basically any digital camera can be modified to "see" it.  Check out Lifepixel.com and Kolarivision.com for more info. As regards lenses, I'm not exaggerating when I say that I have searched with great vigor (and at great expense) for a way to capture IR images with a Fujifilm camera for which I didn't have to use major amounts of sharpening to bring out the best. Zooms, primes, Fuji, Tamron, Viltrox, Sigma, Zeiss ... probably 20 lenses all told. Plus multiple IR converted Fuji cameras, X-T1, X-T3, X-T5. I even tried different ways of filtering IR, such as using the Kolari clip-ins and lens-mounted front filters. I was ready to give up until I almost accidentally tried one of the cheapest lenses out there -- the little TTArtisan 27mm F2.8. No hotspots that I could see, and best of all ABSOLUTELY SUPERB SHARPNESS across the entire frame. It's this attribute that I search for, and until now, never achieved. In my prior attempts, I listened to the advice from the "pundits", picking up a copy of the venerable Fuji 14mm F2.8, the Zeiss Touitt 12mm F2.8, Fuji 23 and 35mm F2.0, even the very similar 7Artisans 27mm F2.8, and none of them come even close to the TTArtisan for edge sharpness in infrared. Incidentally, I'm using a Kolari 720nm clip-in filter. Sure the TT has its issues -- vignetting at 2.8, tendency to flare with sunlight nearby, but all in all, this lens is glued to my X-T5 for now. This image was taken hand-held with this lens -- completely unedited!
    • Greybeard
      XS10 and manual lenses

      By Greybeard · Posted

      No - I don’t think so - it means you can take pictures if you remove the lens completely - but I’m not sure that is a problem
    • mcewena
      XS10 and manual lenses

      By mcewena · Posted

      I bought a manual lens over xmas and it took me a while to find the "shutter w/o lens" function in the menu settings.  So far I haven't found a way to either put that on the Q menu or marry that setting to one of the 4 custom modes.   Am I missing something? Is there a problem if I just leave that setting enabled even when the OEM auto lens is in place? tia
×
×
  • Create New...