Jump to content

Remote flash sync issue at 250


monkeyboy4

Recommended Posts

Hi there,

 

Couldn't find any other topics in this. I was using my xt1 with Yong nuo 622 triggers and Bowens 500s no problem.

 

When using my new xt2 at 250 I get darkening along the edge of the photo. Something is not syncing somewhere but can't figure out what it is.

 

Bought a couple of cactus v6IIs as thought the triggers (canon Yong nuo 622s) may not be playing with the xt2 new flash protocol but same issue with then too

Link to post
Share on other sites

I once had a dark stripe at the bottom of an image when using a Profoto AirRemote/D4 pack at the 1/250 sync speed with the XT-2. I continued shooting at 1/125 to be on the safe side (it was a darkened studio, so no problem). Towards the end, I switched the camera and the trigger off and on and it didn't occur again. My takeaway is to use 1/125 where it doesn't matter (studio @ f8-11) and keep checking my frames from time to time when I need the higher sync speed (outside and/or open aperture).

Edited by albireo_double
Link to post
Share on other sites

Radio triggers introduce a slight flash sync delay - a few milliseconds between the signal being transmitted and being received. I find it's safest to set the sync speed on my XT2 to a max of 1/200 with my Yongnuo triggers, otherwise I often experience the darkening you describe. (As to why the results vary, I guess a range of other factors come into play as well, and maybe others can describe this better.)

Link to post
Share on other sites

I used the SB900 Nikon on top of the XT2 ( on A mode ) and had the same dark line on the bottom of the picture. It was at 1/250. When I took the pics at a speed of 1/200 it was ok. I think it is something whit the speed sincronization and the speed.

 

 

Petru

Edited by petru
Link to post
Share on other sites

  • 2 weeks later...
  • 4 weeks later...

I had same issue with Elinchrom D-Lite RX4 and Skyport Transmitter Plus.. I had little black gradient with 1/250th, second photo..

Welcome, dear visitor! As registered member you'd see an image here…

Simply register for free here – We are always happy to welcome new members!

Link to post
Share on other sites

Jakku, do you have fresh batteries in the transmitters? I sync remote flash with my XT2 at 1/250 with no dark edges almost every day. The only time I had a black bar like that is when I accidentally bumped the wheel on the back that turned the shutterspeed up to 1/320. 

 

I've never used Skyport triggers so I'm not sure how they work, but can't you adjust the timing on them so the flash fires earlier or later? Maybe the timing is off? Or maybe I'm thinking about a different model of Skyports. Either way, I think the black bar is caused by the transmitters being a little slow. 

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

  • Posts

    • Im not partal to any brad, just opted to try these based on apparent price / performance.  I'm always looking for best bang per buck, hence Fuji I guess - haha Reliabilty does not concern me, as I always shoot to two cards for pro work (and burst shooting is not a part of that). Made sense for me to get the cheapest / fastest CF cards for hobby shooting.     I just got a Sabrent Rocket V60 512GB cheep (as the back-up card).   As long as neither of these freeze the camera I hope its a cheep solution for my needs. (AB AV Pro SE 512Gb and Sabrent Rocket V60 512GB).  Half a gig of redunat storge for $200USD is something I can live with. (Especially considering I can bust the hell out of the Anglebird). Cheers, Tomek
    • Would using an external charger be of benefit to the batteries life? I appreace it can be faster, but I doin't mind pluging in the camera over USB to charge. Does charging via the camera do as good a job as lets say the fuji's own external charger? Does the camera stop charging once the battry is full and not over charge? I couldn't find these deatails in these forums or in the manual. Thank you!   Image below shot on X-T2 in a sunny studio.  

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

    • It is really easy to find out if the wifi is on. Your computer or tablet or cell phone will have a network settings dealing with wifi, bluetooth, ethernet or “other”. Open that up and go into the section for wifi, and take note of which networks are listed. Turn on the camera and keep watching the list of networks. If your camera’s wifi is turned on, a new network should suddenly show up in your computer/tablet/phone’s network listings. Now go into the camera’s menus and start a wireless connection (the x-app or camera remote app can help you with this). You should see a network show up now. It is not hidden because it has to be visible so that your computer/tablet/phone can join the camera’s network to transfer images. Turn the camera off and that network should disappear. Turn the camera back on and see what happens.
    • Sweet Creek Falls, Oregon. X-H1, Viltrox 13mm F1.4, Acros.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

    • I think my Fuji 150-600 F8 is a brilliant wildlife lens in terms of sharpness, portability and value but the small aperture does cause issues at the start and end of the day - even pushing the ISO as far as I dare, I can see shutter speed down to 1/25s - stabilisation isn't an issue but asking a deer to stand still for that is too much! In the same situation, an F4 would give 1/100s so the difference to the success rate would be phenomenal... and that's without the other improvements like shallower depth of field. I also find that the Fuji's subject detect AF gets pretty iffy in low light - I keep updating to the latest firmware but it doesn't seem to get any better. I was originally looking at the Nikon 500mm F4 E but good examples secondhand are still reasonably expensive but like-for-like Sigma lenses are around half the price. Reviews I have read suggest that they are as good optically, AF performance and IS-wise but you gain a few hundred grams of weight (but less than the older Nikon model). For a couple of grand, I can live with that. Does anyone have any experience mounting one on an XH2S? What about with the 1.4 teleconverter? It feels like that is pushing it anyway - hefty lens + TC + Fringer all sounds a bit...wobbly? It is on the Fringer approved list but I am wary about AF speed in particular. I had also considered looking for a used Nikon 400mm F2.8, which would be even faster (and heavier) and could couple with a TC to give 560mm F4 but again, it is that lens+TC+Fringer combination that worries me as being just too many links in the chain. Of course, what I really want is a native Fuji prime but that doesn't seem to be on the horizon - and if you look at what Nikon and Sony are doing, if Fuji do ever bring out a 500mm prime, it will probably be a small, light and cheapish F5.6, which is only 2/3 stop better than my zoom at the same focal length. Any thoughts anyone?
×
×
  • Create New...