Jump to content

Recommended Posts

First of all, all those settings are only (mostly ?) applied to the jpeg output files.

 

If you shoot RAW files, none of the above matters.

 

And if you shoot jpeg directly, there are no one settings for all. You will need to change them on regular basis depending on your subject. Sometimes you will have more light, other times you want to keep the reflection on water (think of port cities).

 

What I usually have is have the NR at 0 or -1 and Sharpening at around 0 or +1 depending on how bad it looks from the LCD.

 

As for film simulation, I like Provia a lot but if there are a lot of colors and I want deeper night too, I swap to Velvia. 

 

Little side note, on the bracketing option, you can go for Film Simulation, just pick 3 of them that you like/want to try and take the shot. You will be rewarded with 3 jpeg files with each their own film simulation, kind of handy if you are unsure which one would come out the best for the scenery.

Link to post
Share on other sites

Yeah, low NR, although I do use Long Exposure NR (black frame NR). Definitely go with raw+Fine. Fine so that you can gauge your shots in camera and raw to have all the latitude the raw file allows for later. Use low ISO (200) and small aperture (I prefer 11 +/1 one stop).

 

Get a good tripod. Get a cheap cable remote release, you can't go beyond 30 seconds without one. Rest of the settings don't matter too much. Learn how to operate full manual to get the most out of it.

 

It's really not hard, go out and shoot some, take a look at the results, go out again and repeat with the experience from last time. It takes a few times to get some nice shots, but it's a lot of fun. 

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Posts

    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • Anyone out there have any experience/feedback on the Laowa 55 mm tilt shift? I’d be using it on the GFX 50s ii. 
    • Hi, I'm researching a gimbal to get someone as a present & they use a Fuji XS-10. I did a quick search of previous threads on gimbals but all of them seem to either get no replies or spammed by a link to an Amazon list. I'd appreciate any comments from folks who've actually used specific gimbals with the XS-10. I'm aware that some, such as certain models from Zhiyun, DJI & FeiyuTech either don't say that they are fully compatible with the XS-10 but other sites say they do work ok but some functions don't. It's quite difficult to work out which functions work & which don't. Thanks.
    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • This was snapped during a lunch.  Total shooting time—a few seconds. We so often read that a proper "portrait" should be snapped with a longer than normal lens, a low ISO to get lots of detail, and have a soft light held up above the head, and slightly to the side. The key, in my opinion, is always carry a camera.  Have your camera available to capture candid, authentic photographs.  Available light, no posing.   This portrait used 2000 ISO, the lens wide open at f4, and 1/100 sec. to stop any movement.  I didn't even take time to compose—I just snapped.  I leave the "Face Detection" on unless I'm photographing a landscape or subject other than a person. The GFX100RF has the equivalent of a 28mm lens.  The large sensor renders fine detail even at fairly high ISO ratings.  And the drawing of the lens is just perfect in my opinion.  It was set to B & W, with slightly reduced sharpness and clarity (set in-camera).  Ideal for "portraits."  Now, for some subjects I will likely increase the sharpness and clarity to the normal setting.  The camera is new, and I'm still experimenting with it.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

×
×
  • Create New...