Jump to content

Recommended Posts

Hi all. Your assistance / advice will be greatly appreciated.

I use an XT3, and acquired the Godox 350 and Godox X1T remote trigger. For some reason, the remote trigger will not fire the flash off-camera. The following may be relevant:

  • When I have both the remote trigger and the flash off the camera, the test button on the remote trigger does fire the flash.
  • When the flash is on the camera, I works perfectly in all modes.
  • When the remote trigger is on the camera, it fires the flash when I press the test button on the remote trigger
  • When I press the shutter it does NOT fire the flash.
  • When the remote trigger is on the camera, the only flash setting available are Off and Manual.

From the above, it would seem to me tat both the flash and the remote trigger in fact work, but that either:

  • The remote trigger is not compatible with the XT3; OR
  • There is some setting on the XT3 that I need to adjust.

Any thoughts or experience with this equipment?

Regards and take care.

 

 

 

Link to post
Share on other sites

  • 5 months later...

Hi there

Does the X Pro F or the X1 f work with Fuji xt4 as when I have looked it has only mentioned the x-h1 xt3 and some older cameras.

 

I am looking to purchase the Godox 400ii and want to ensure all channels of communication are compatible.

can anyone assist 

cheers

xennii 

 

 

Link to post
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Posts

    • All three of my bodies (X-E2, X-T4, GFX100S II) have shoot without lenses enabled and they have all had it set since I bought them.  No harm in it at all. Just remember to set the focal length when you fit a manual lens with no electronics otherwise the IBIS (if you have it) goes nuts. I regularly use vintage film lenses from Minolta, Zeiss, Mamiya, Rollei and others on my X mounts along with more modern manual focus stuff from TTArtisans. I also use Nikon AF-S lenses with a Fringer so the world is your oyster! Vintage lenses can be an absolute bargain too - For example the Zeiss 135 f/35 in M42 is as cheap as chips and very sharp as is the excellent Minolta 35-70 Macro (which is also rebadged Leica). 
    • I'm not exaggerating when I say that I have searched with great vigor (and at great expense) for a way to capture IR images with a Fujifilm camera for which I didn't have to use major amounts of sharpening to bring out the best. Zooms, primes, Fuji, Tamron, Viltrox, Sigma, Zeiss ... probably 20 lenses all told. Plus multiple IR converted Fuji cameras, X-T1, X-T3, X-T5. I even tried different ways of filtering IR, such as using the Kolari clip-ins and lens-mounted front filters. I was ready to give up until I almost accidentally tried one of the cheapest lenses out there -- the little TTArtisan 27mm F2.8. No hotspots that I could see, and best of all ABSOLUTELY SUPERB SHARPNESS across the entire frame. It's this attribute that I search for, and until now, never achieved. In my prior attempts, I listened to the advice from the "pundits", picking up a copy of the venerable Fuji 14mm F2.8, the Zeiss Touitt 12mm F2.8, Fuji 23 and 35mm F2.0, even the very similar 7Artisans 27mm F2.8, and none of them come even close to the TTArtisan for edge sharpness in infrared. Incidentally, I'm using a Kolari 720nm clip-in filter. Sure the TT has its issues -- vignetting at 2.8, tendency to flare with sunlight nearby, but all in all, this lens is glued to my X-T5 for now. This image was taken hand-held with this lens -- completely unedited!
    • Hy there When Im using the fan001 on the XH2s and I flip the LCD Screen vertically by 180 degrees then the image flips vertically, what is good but it also flips horizontally. The clean feed on HDMI is not flipping horizontally but its also flipping if the HDMI output info display is on. When I unmount the fan then the image flips only vertically. My firmware is updated to the latest version. Any ideas if there is a fix for that?
    • In reply to the original question, it all depends on what you mean by infrared.  If you mean "see thermal information", then I agree with the comments here.  However, if you mean near-infrared, the X-T4, or basically any digital camera can be modified to "see" it.  Check out Lifepixel.com and Kolarivision.com for more info. As regards lenses, I'm not exaggerating when I say that I have searched with great vigor (and at great expense) for a way to capture IR images with a Fujifilm camera for which I didn't have to use major amounts of sharpening to bring out the best. Zooms, primes, Fuji, Tamron, Viltrox, Sigma, Zeiss ... probably 20 lenses all told. Plus multiple IR converted Fuji cameras, X-T1, X-T3, X-T5. I even tried different ways of filtering IR, such as using the Kolari clip-ins and lens-mounted front filters. I was ready to give up until I almost accidentally tried one of the cheapest lenses out there -- the little TTArtisan 27mm F2.8. No hotspots that I could see, and best of all ABSOLUTELY SUPERB SHARPNESS across the entire frame. It's this attribute that I search for, and until now, never achieved. In my prior attempts, I listened to the advice from the "pundits", picking up a copy of the venerable Fuji 14mm F2.8, the Zeiss Touitt 12mm F2.8, Fuji 23 and 35mm F2.0, even the very similar 7Artisans 27mm F2.8, and none of them come even close to the TTArtisan for edge sharpness in infrared. Incidentally, I'm using a Kolari 720nm clip-in filter. Sure the TT has its issues -- vignetting at 2.8, tendency to flare with sunlight nearby, but all in all, this lens is glued to my X-T5 for now. This image was taken hand-held with this lens -- completely unedited!
    • No - I don’t think so - it means you can take pictures if you remove the lens completely - but I’m not sure that is a problem
×
×
  • Create New...