X-T20 aperture control?

[NHKeith]

When I unboxed my camera the aperture was controlled using the command dial. I used the menu to change it to using the aperture ring on the lens, now I want to go back to using the command dial but can't figure out how. The setup -> button/dial -> aperture setting menu is disabled because all my lenses have aperture rings. Any suggestions? Thx

[milandro]

I am sure this is like any other X camera, on your lens you either have a A position or a sector between A and Aperture

[NHKeith]

The lens has A and aperture switch. On aperture setting, the ring on the lens changes aperture. I am trying to make the command dial on the body change aperture.

[milandro]

when you put it on a, no dial changes the aperture?

[NHKeith]

when you put it on a, no dial changes the aperture?

That is right. The aperture ring on the lens changes aperture but neither of the dials change it.

[Tikcus]

without checking (as cba) like every other x-series camera to date, when a lens has an aperture ring, the rear dial (or front if switched) will only change the aperture in program mode (where it will also change the shutter speed, to keep the metered exposure

[NHKeith]

without checking (as cba) like every other x-series camera to date, when a lens has an aperture ring, the rear dial (or front if switched) will only change the aperture in program mode (where it will also change the shutter speed, to keep the metered exposure

Thanks. That explains why I was once able to control aperture with the command dial. I thought I must have changed a config setting but the camera must have been in program mode.