Jump to content

Recommended Posts

Having trouble deciding between the good old 23mm f/1.4 and the newer 23 f/2 for my new Fuji setup. I've owned the 1.4 before, and found it nothing short of stellar optically. I did notice the AF speed and noise occasionally, though, and it used to annoy me sometimes.

 

The f/2, when I tried it in a shop, had much, much better AF speed/silence and smoother MF. It's also a fair bit smaller and lighter of course. I heard some reports that it can be a little soft wide-open on closer subjects, but not sure how true this is in real-world use(?).

 

I'm tempted by the f/2 in that my other lenses will very likely be the 35 f/2 and the 50 f/2, so it would be nice to have the set, as it were. However, I'm worrying I'll miss that extra stop, and the excellent sharpness of the 1.4...

 

Anyone BTDT and formed any conclusions?

 

Use is landscape, street, travel (the latter two involving casual environmental and 'grab' portraits) I do open the lens up for portraits and used to find the 1.4 was just nice in terms of separation and a nice-ish bokeh.

Link to post
Share on other sites

You can have nice separation and bokeh also at f/2.

I own a f/2, I owned a f/1.4 for a couple days, resold it almost istantly. It had a bad colour fringe and it wasn's sharp at all. My f/2 is way better.

Having said so, you should try more samples of the same lens, having the chance.

Not 2 lenses are the same and my ex F/1.4 was probably one of the few? Many? not being well built.

Edited by lleo
Link to post
Share on other sites

Thanks, that’s interesting you preferred your f/2 even optically. Yes, I think it sounds like you were a bit unlucky though, as my 1.4 is very nice. It does have a little CA wide open at high contrast edges, but I’ve never noticed any more than a tiny amount (and nothing which ruined any good shots) and it’s super sharp.

 

I think in every respect I would get the f/2, except that I have had some nice environmental grab portraits at f/1.4 and I’m not sure if they would have been as nice with the f/2 - hard to tell, or course, without having shot the same photo side by side! Having said that, the nicest of these was cropped to the extent that the best lens for the shot would have actually been the 35mm, but of course in the moment one doesn’t always have time to swap lenses. There is the real strength of the 23 f/1.4 I guess - you have room to crop and as much isolation as the 35 f/2...

 

It depends so much on subject and background distance that it would be hard to quantify it except in careful side by side tests, I guess.

Link to post
Share on other sites

You also have to put on the dish the different prices. How much one does worth the difference?

I had the chance to make a comparison between the 35mm and the f/2 is a little wider, talking about fow, than the other. However in this case the f/1,4 is much more detailed and sharp.

Maybe is the same for the 23mm though I haven't made the same comparison when I had both.

 

post-9661-0-86128400-1505056642.jpg
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Posts

    • Here is the solution to using the Eterna 55 file simulation LUTs in Davinci Resolve.   In general, do not use the FLog2C to film simulation LUTs as they are not supported by Davinci Resolve for two reasons: 1) Davinci Resolve does not support Fuji Gamut Color Space and 2) Davinci Resolve does not support FLog2C gamma.  Instead, use Flog2 which is supported by Davinci Resolve.  Here is an example.  Let's say that you want to use Classic Chrome simulation.  Do the following: Complete your color grade and use a CST to get to Rec 709. Add a node.  Use a CST to convert from Rec 709 to FLog2.  Output Color space is Rec 2020 and Outout Gamut is FLog2. Add a node.  Apply the FLog2 to Classic Chrome LUT Create a combination node from node in steps 2 and 3. Apply a Key to the combination node and adjust the Key Output Gain to get the amount of the combination node that you want applied. So that you do not have to do this over and over again, generate a LUT for the combination node.  Remember to turn off all other nodes before generating the LUT. Hope this helps others. Don  
    • Thanks for the insights. I think it's really hard to make a decision without having the two side by side! 
    • I don’t have the 23 f2 but I have read several times that it is considered a little soft at close distance, compared to the 23 f1.4 lenses. These will also focus at shorter distance from the subject, esp. the new one. So that might make a difference. The new 23 f1.4 LM WR  has better resolution, esp. in regard to the 40Mpix sensors, which you don’t have on the X-T2. What practical difference that makes for the value of the pictures one makes is disputable and subjective.  f1.4 will gather more light but with a smaller DOF, which may be desirable in some situations but not so in others, depends. If you like to shoot close ups, you will probably use higher f numbers to get a bigger DOF. Same for landscapes. If you are a bokeh fan, yes the f1.4 lens are better.  The older 23 f1.4 lens that you are considering is a very good and respected lens. The f1.4 vs f2 aperture per se is perhaps not so important. The 23 f2 is very small, light and practical and a great lens for travel and landscapes. So, go figure. I am afraid I just sent you further down the road to insanity !
    • First post here but long time fuji shorter. I use the XT2 with the 23mm f2 / 35mm 1.4 / 16-80mm f4 I'm considering the 23mm f1.4 r (Non-WR) About me: - I shoot black and white only. - I like macro details to wide open landscapes and everything in-between. - I shoot mostly for art, intrigue and creativity of the image. My question - is the 23mm f1.4 going to offer me any meaningful difference over the f2 for the above scenarios Thanks and sorry for bringing it up again...
    • I discovered this unmarked government installation today.  

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

×
×
  • Create New...