Jump to content

Recommended Posts

Not many people will have this combination of cameras, so not sure how many replies you will get.

Actually I wrote it just to let others know that X-A2 with 16MP bayer could be a better choice over X-T20 with X-Trans if you don't need extra 4K.

Probably even better than X-A3, I have a quick test of X-A3 comparing it to X-T20 ( I was deciding which to buy), so I took several shots with X-A3 and X-T20,

and X-A3 didn't give better results than X-T20, in some cases it was noisier. But it was a handheld shots, not from 100% exact position. So according to those shots I choose X-T20.

Probably not a good decision which I'm regretting now. Especially after I tested focus abilities of X-T20 in low light conditions. Which is almost identical to X-A2 if used with 56mm. 60mm, 90mm, 50-230mm

although it was pretty fast with 16mm 1.4, 30mm 1.4, much faster than X-A2.

Link to post
Share on other sites

  • 1 month later...
  • 3 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Posts

    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • Anyone out there have any experience/feedback on the Laowa 55 mm tilt shift? I’d be using it on the GFX 50s ii. 
    • Hi, I'm researching a gimbal to get someone as a present & they use a Fuji XS-10. I did a quick search of previous threads on gimbals but all of them seem to either get no replies or spammed by a link to an Amazon list. I'd appreciate any comments from folks who've actually used specific gimbals with the XS-10. I'm aware that some, such as certain models from Zhiyun, DJI & FeiyuTech either don't say that they are fully compatible with the XS-10 but other sites say they do work ok but some functions don't. It's quite difficult to work out which functions work & which don't. Thanks.
    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • This was snapped during a lunch.  Total shooting time—a few seconds. We so often read that a proper "portrait" should be snapped with a longer than normal lens, a low ISO to get lots of detail, and have a soft light held up above the head, and slightly to the side. The key, in my opinion, is always carry a camera.  Have your camera available to capture candid, authentic photographs.  Available light, no posing.   This portrait used 2000 ISO, the lens wide open at f4, and 1/100 sec. to stop any movement.  I didn't even take time to compose—I just snapped.  I leave the "Face Detection" on unless I'm photographing a landscape or subject other than a person. The GFX100RF has the equivalent of a 28mm lens.  The large sensor renders fine detail even at fairly high ISO ratings.  And the drawing of the lens is just perfect in my opinion.  It was set to B & W, with slightly reduced sharpness and clarity (set in-camera).  Ideal for "portraits."  Now, for some subjects I will likely increase the sharpness and clarity to the normal setting.  The camera is new, and I'm still experimenting with it.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

×
×
  • Create New...