Jump to content

Recommended Posts

My X-T4 will freeze up from time to time when I turn it on. I can feel something in the camera engage (I think the lens focussing system) and then the camera will do nothing. Turning it off and on again won’t do anything and it will be frozen until I pull out the battery.

I sent it for repairs and waited three months for the repair to finish. In the end they ended up replacing the screen (???). Now I finally got it back a few days ago and it just froze up again. Does anybody also have this problem with the X-T4? I’m on the latest firmware. I don’t know what to do now and I’m not looking forward to sending it away for repair again.

 

I’m using two Sabrent 128gb UHS-II SD cards.

Edited by Fenjen
Link to post
Share on other sites

  • Fenjen changed the title to Occasional Freezing when Turning On

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Posts

    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • Anyone out there have any experience/feedback on the Laowa 55 mm tilt shift? I’d be using it on the GFX 50s ii. 
    • Hi, I'm researching a gimbal to get someone as a present & they use a Fuji XS-10. I did a quick search of previous threads on gimbals but all of them seem to either get no replies or spammed by a link to an Amazon list. I'd appreciate any comments from folks who've actually used specific gimbals with the XS-10. I'm aware that some, such as certain models from Zhiyun, DJI & FeiyuTech either don't say that they are fully compatible with the XS-10 but other sites say they do work ok but some functions don't. It's quite difficult to work out which functions work & which don't. Thanks.
    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • This was snapped during a lunch.  Total shooting time—a few seconds. We so often read that a proper "portrait" should be snapped with a longer than normal lens, a low ISO to get lots of detail, and have a soft light held up above the head, and slightly to the side. The key, in my opinion, is always carry a camera.  Have your camera available to capture candid, authentic photographs.  Available light, no posing.   This portrait used 2000 ISO, the lens wide open at f4, and 1/100 sec. to stop any movement.  I didn't even take time to compose—I just snapped.  I leave the "Face Detection" on unless I'm photographing a landscape or subject other than a person. The GFX100RF has the equivalent of a 28mm lens.  The large sensor renders fine detail even at fairly high ISO ratings.  And the drawing of the lens is just perfect in my opinion.  It was set to B & W, with slightly reduced sharpness and clarity (set in-camera).  Ideal for "portraits."  Now, for some subjects I will likely increase the sharpness and clarity to the normal setting.  The camera is new, and I'm still experimenting with it.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

×
×
  • Create New...