X100V - "Interlock Spot AE & Focus Area" in Manual mode
-
Similar Content
-
-
Posts
-
I also have the eaxct problem with my X-T5. The remote used to work, but not anymore. I also get the light coming on on the camera back, and autofocus will happen, but no shutter release. Since I use the 2 or 10 seconds timer more I don't know if a firmware update is the cause of this negative change. I actualley only use the wired jack-remote for action release on a tripod. Did anybody find a cause, and even more assisting, a solution? -
I have the same issue. Have you found the the solution? -
Welcome, dear visitor! As registered member you'd see an image here…
Simply register for free here – We are always happy to welcome new members!
-
By Rich Martin · Posted
On my XPro 2 the rear command dial, when pressed, can cycle through 3 different magnification levels in the OVF. -
I have analog film recipes in C1 through C6 on the GFX100s. I can rotate the Mode Dial to change recipes, or I can access the "Q" button to review the recipe name until I memorize it or make changes. Is there any other alternative ways to access these Custom Modes (C1-C6), or to make their names appear on one of the available LCDs? Thank you very much.
-
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now