Jump to content

Compact Travel Video Rig


corama

Recommended Posts

questions for video folks.... any clues?

1. I'm looking for a very compact stabilization rig for X-T2 to make quick videos (specially while walking) that can fit in my travel bag. I do not need pro grade rigs, just want to avoid getting a headache every time I watch the videos....

2. would the AF noise of the 23 1.4 or 56 be picked by camera mic?? should I use an external mic instead?

thanks!

Link to post
Share on other sites

At some point in the future I want to explore the video functionality of my X-T2 as well. I was looking at:

- Feiyu MG gimbal http://www.feiyu-tech.com/products/31/ (around 650-800 euro)

- Sirui video monopod http://www.sirui.eu/en/products/monopods/ps-series/ (around 170-300 euro voor monopod only, 150 euro voor fluid video head)

 

Cheaper option is a steadycam, like the Ringlight Steadycam Stabilizer S40 for 150 euro.

Link to post
Share on other sites

Did some tests in my X-T1 with the 18-55mm F2.8-4 OIS.  Standing still, I can shoot video as on a tripod.  When walking on smooth ground, if I work really hard, I can shoot smooth video.  Sometimes.  Rough ground, there is too much motion.  35mm seems to be the limit where it starts to look really bad.  

 

The worse is the pan, as the OIS seems to allow pan mode and look at just tilt stabilized.  Then the pan stops abruptly and reverse.  Really not good enough.  

 

I'll have to try it with a folded up tripod or monopod for some more mass, but I would have no problems with video from a still position.  Especially with a monopod in the mix.

Link to post
Share on other sites

Make sure to pick up ND filters for the lenses with which you want to shoot video.  In sunlight, I had to use stacked 8, 4, and 2 stop ND filters to get the frame rate down to 1/60 at ISO 200 and 2.8 aperture (These are cheap ND filters so they may be only 10-12 stops total.  If you haven't done much video, you need to keep the shutter speed at about 2x frame rate for smooth looking video.  Otherwise, you get strobing instead of motion blur.  That makes video much harder to watch. 

Edited by sacherjj
Link to post
Share on other sites

@sacherjj

 

Make sure to pick up ND filters for the lenses with which you want to shoot video.  In sunlight, I had to use stacked 8, 4, and 2 stop ND filters to get the frame rate down to 1/60 at ISO 200 and 2.8 aperture (These are cheap ND filters so they may be only 10-12 stops total.  If you haven't done much video, you need to keep the shutter speed at about 2x frame rate for smooth looking video.  Otherwise, you get strobing instead of motion blur.  That makes video much harder to watch. 

 

Good to know, thanks for the advice, I do have a ND, but  I think is only a 4. Will work if I shoot at f8 or f16 to get to 1/60? just to test what you say and then after I get some experience I may get more ND filters.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

  • Posts

    • So I ended up getting and X-H2 over the X-T5 because of a good deal that came up.  Needing to buy a card, I needed to figure out,  what is the real impact of a card's speed for photos?   In particular, I'm going to test how shooting at 15 FPS will differ between: Angelbird - AV PRO CFexpress B SE - 512 GB and Angelbird AV PRO CFexpress SX - 160 GB. How many shots can I get off before buffer fills, and how long does it take for the buffer to clear?    MOP: X-H2 Factory rest, card formated, no lens (body cap on), performance boost on, manual exposure, mechanical SS @ 1/8000, IS off, Shoting RAW Compressed Lossless with only one card in. Held shutter release till buffer filled, and used stop watch to see how long for buffer to clear. Subtracted two frames from total taken as that's how long it takes me to release the trigger once the buffer is full. Repeat 2x for sanity check.   ***TEST RESULTS***   ~~~64GB Lexar Pro SD 150MB/s~~~ 75 shots to fill buffer, 36 Seconds to clear it   ~~~Angelbird AV Pro SX 160GB~~~ 251 shots to fill buffer, 5 Seconds to clear it   .~~~Angelbird AV Pro SE 512GB~~~ 232 shots to fill buffer, 4 Seconds to clear it     ***Conculsion***   If burst shooting an X-H2 at 15 FPS is your thing, buy the Anglebird 512GB SE for the same price as the 160GB SX.   Below is a shot on X-T2 w/ the Fuji 70-300. I manged to fluke it off with a dead battery by turning the camera off and on again, and squeezing three more shots out (this was the last shot).   Ta for now!

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

    • Xt5 firmware updated and now cannot see pics taken on lcd when pressing playback. Any ideas please? Elie
    • Have you tried a factory reset? Maybe you changed unintentionally a setting?
    • Hello. I have a x-s10 that I use multiple lenses with. Yesterday I noticed that with the Fujinon 16mm lens I'm having issues auto-focusing. It works on video but not for still images. When I half press the button it focuses a bit then when I release the button it snaps back to the previous focus point. Even though it manages to focus the image is still blurry. Any ideas please. I already did a a major google search and nobody has mentioned this issue. Thanks, Etienne   
×
×
  • Create New...