Jump to content

Recommended Posts

Dear all, with the new generation 40 MP sensors I see a few problems coming for myself and I wonder whether anybody shares my concerns or has some feedback on where the XF journey will be going. Note that I'm a regular "consumer", not photographing for career, Instagram or bread on my table.

40 MP means large raw files and more detail than I effeively need. To me, 26 MP was the perfect compromise, matching the apsc format. It also seems that lenses to utilize the higher resolution are getting heftier and I always liked the overall small format: I'm shooting XE4 with the old 18/f2 and 35/f1.4.

 

- Will 26 MP sensors survive for the other, photo centric, camera systems?

- If not, may there be a possibility with xtrans to do resolution reduction for raw files via binning?

- Will Fuji go fully towards modern, and larger, high Res lenses and abandon their approach for small "character lenses" (eg XF 35/f1.4)?

- Does anybody else feel ambivalent about the MP increase? And don't tell me that storage is getting ever cheaper. That's another problem creating solution for a self inflicted and, in my case, in the first place unnecessary problem (i.e. stupid).

For complaint on too much sharpnes/resolution, see also this thread:

Many thanks!

A

 

 

 

Link to post
Share on other sites

There certainly is a lot to wonder about as autumn starts getting ready to show up. But ...

Fujifilm released a list of lenses that will work just fine with 40mp sensors -- a very long list.

https://www.fujirumors.com/list-of-fujinon-xf-lenses-that-get-maximum-benefit-from-fujifilm-x-h2-and-x-t5-with-40-megapixel-resolution/

From the article:

"Let’s be clear: more or less every single Fujifilm XF lens will perform better on the 40MP sensor. So even if an older lens can’t really resolve all the 40MP, they will still perform better than on the current 26MP sensor. Some might resolve 30MP, others 33MP, others more or less".

If you look, Fujifilm has been letting you bin the files to smaller sizes for quite a while, even in your XE4 you can do this, look under the setting for recorded pixel sizes -- in your case you can drop from 6240 x 4160 down to 2080 x 2080.

Sharpness is only one quite desirable aspect of an image, overall there are several other aspects the new sensors will give photographers, if an image is too sharp it can be softened.

I do not think Fujifilm is going to just abandon the smaller sensor based cameras, after all they sell a whole lot of the Instax line, those are not XH2(s).

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Posts

    • I'm not exaggerating when I say that I have searched with great vigor (and at great expense) for a way to capture IR images with a Fujifilm camera for which I didn't have to use major amounts of sharpening to bring out the best. Zooms, primes, Fuji, Tamron, Viltrox, Sigma, Zeiss ... probably 20 lenses all told. Plus multiple IR converted Fuji cameras, X-T1, X-T3, X-T5. I even tried different ways of filtering IR, such as using the Kolari clip-ins and lens-mounted front filters. I was ready to give up until I almost accidentally tried one of the cheapest lenses out there -- the little TTArtisan 27mm F2.8. No hotspots that I could see, and best of all ABSOLUTELY SUPERB SHARPNESS across the entire frame. It's this attribute that I search for, and until now, never achieved. In my prior attempts, I listened to the advice from the "pundits", picking up a copy of the venerable Fuji 14mm F2.8, the Zeiss Touitt 12mm F2.8, Fuji 23 and 35mm F2.0, even the very similar 7Artisans 27mm F2.8, and none of them come even close to the TTArtisan for edge sharpness in infrared. Incidentally, I'm using a Kolari 720nm clip-in filter. Sure the TT has its issues -- vignetting at 2.8, tendency to flare with sunlight nearby, but all in all, this lens is glued to my X-T5 for now. This image was taken hand-held with this lens -- completely unedited!
    • Hy there When Im using the fan001 on the XH2s and I flip the LCD Screen vertically by 180 degrees then the image flips vertically, what is good but it also flips horizontally. The clean feed on HDMI is not flipping horizontally but its also flipping if the HDMI output info display is on. When I unmount the fan then the image flips only vertically. My firmware is updated to the latest version. Any ideas if there is a fix for that?
    • In reply to the original question, it all depends on what you mean by infrared.  If you mean "see thermal information", then I agree with the comments here.  However, if you mean near-infrared, the X-T4, or basically any digital camera can be modified to "see" it.  Check out Lifepixel.com and Kolarivision.com for more info. As regards lenses, I'm not exaggerating when I say that I have searched with great vigor (and at great expense) for a way to capture IR images with a Fujifilm camera for which I didn't have to use major amounts of sharpening to bring out the best. Zooms, primes, Fuji, Tamron, Viltrox, Sigma, Zeiss ... probably 20 lenses all told. Plus multiple IR converted Fuji cameras, X-T1, X-T3, X-T5. I even tried different ways of filtering IR, such as using the Kolari clip-ins and lens-mounted front filters. I was ready to give up until I almost accidentally tried one of the cheapest lenses out there -- the little TTArtisan 27mm F2.8. No hotspots that I could see, and best of all ABSOLUTELY SUPERB SHARPNESS across the entire frame. It's this attribute that I search for, and until now, never achieved. In my prior attempts, I listened to the advice from the "pundits", picking up a copy of the venerable Fuji 14mm F2.8, the Zeiss Touitt 12mm F2.8, Fuji 23 and 35mm F2.0, even the very similar 7Artisans 27mm F2.8, and none of them come even close to the TTArtisan for edge sharpness in infrared. Incidentally, I'm using a Kolari 720nm clip-in filter. Sure the TT has its issues -- vignetting at 2.8, tendency to flare with sunlight nearby, but all in all, this lens is glued to my X-T5 for now. This image was taken hand-held with this lens -- completely unedited!
    • No - I don’t think so - it means you can take pictures if you remove the lens completely - but I’m not sure that is a problem
    • I bought a manual lens over xmas and it took me a while to find the "shutter w/o lens" function in the menu settings.  So far I haven't found a way to either put that on the Q menu or marry that setting to one of the 4 custom modes.   Am I missing something? Is there a problem if I just leave that setting enabled even when the OEM auto lens is in place? tia
×
×
  • Create New...