Jump to content

Recommended Posts

11 hours ago, Caslon Bodoni said:

Does the electronic shutter eliminate any camera shake? Is it best to just always use it?

Sorry if its a dumb question but coming from the DSLR world.

I have not noticed that electronic shutter reduces camera shake for regular usage, but IF you using the camera in situations such as connected to a microscope when you are photographing highly magnified subjects, the mechanical shutter may have just enough shake that it blurs the image a bit so ES is a better choice.

It may seem like a better choice to just use ES, but there are a lot of lighting situations where you can get banding in the images because of how the sensor is read for ES vs MS. Even LED lighting can cause this if the controller running the LEDs use Pulse Width Modulation (PWM).

If your subject moves a lot; puppies, kittens, birds in flight, etc. MS can give you better results. Again, due to how the sensor is read during the shot.

Fujifilm says this:

https://fujifilm-x.com/en-us/stories/advanced-month-3-motion-9-electronic-shutter/

 

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Posts

    • I never knew the X70 existed! Looks interesting.
    • Equipment: Fujiflim X-M5 (firmware V 1.10). iPhone 15 pro (26.1) I am unable to properly connect my Fujifilm X-M5 to XApp on my iPhone 15 Pro. This setup previously worked without issues, but now the app only supports a basic remote shutter and no longer allows Get or Take mode, which are required for remote parameter control and shooting. I have repeatedly Initialized “FUJIFILM XApp”, re-paired the camera, reset wireless settings, and confirmed the camera is not in airplane mode, with both devices placed next to each other. None of these steps resolved the issue. Also, I am unable to update the camera firmware, as the process always fails with a “connection failed” message. I need clarification on whether this is a known firmware or compatibility issue and what the actual solution is.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

    • Last day of autumn 2025. Autumn is gradual. Summer field crops slowly ripening. Cool, longer nights turn into morning fogs. Color (colour) touches here and there taking the place of flowers now resting until Spring. Then, after that slow introduction, Fall is everywhere. Winter is brash, Winter is not at all subtle. Freezing cold days and colder nights. The Sun struggles to get above the horizon. Bare fields, iced over streams and woe (‘Woe!! I say!’) to trees or shrubs holding onto leaves.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

        But there is sledding, skiing and hot chocolate for those that like those things 😀.
    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

      Winter is coming.
    • For some reason, the EV dial setting does not correlate to the EV setting displayed in the viewfinder.  My XT2 used to have parity between settings such that when the dial was at "0", the viewfinder also showed "0".  Has anybody else noticed this?  I've tried a reset of the s/w but no luck.  
×
×
  • Create New...