Jump to content

Setting the frame counter for time lapse

NikVladi

By NikVladi
in General Discussion

 Share

Recommended Posts

NikVladi Rookie

NikVladi

Posted
Posted (edited)

I propose to influence the head office to make a normal mechanism for selecting the number of time-lapse images in the firmware. Now you need to hold the lever until the counter winds as much as necessary. If you do it wisely, there should be three counters - hundreds, tens and ones. For example, all zeros are infinity. Let's say I need to jump from 330 frames to infinity. I hold the lever for about a minute. Then back. Again about a minute. With three counters, I would have to spend a maximum of ten seconds.

I'm sure it's the same nonsense on other models. I'm really tired of this already!To the left everything is fine with time. It was necessary to make one counter there too so that we would all go crazy...

Before:

Welcome, dear visitor! As registered member you'd see an image here…

Simply register for free here – We are always happy to welcome new members!

For example like this. Or do as with the time on the left. After:

Edited by NikVladi
Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing

  • Similar Content

  • Posts

    • dsingley
      G mount tilt shift

      By dsingley · Posted

      Anyone out there have any experience/feedback on the Laowa 55 mm tilt shift? I’d be using it on the GFX 50s ii. 
    • jshire
      gimbals (& threads getting spammed)

      By jshire · Posted

      Hi, I'm researching a gimbal to get someone as a present & they use a Fuji XS-10. I did a quick search of previous threads on gimbals but all of them seem to either get no replies or spammed by a link to an Amazon list. I'd appreciate any comments from folks who've actually used specific gimbals with the XS-10. I'm aware that some, such as certain models from Zhiyun, DJI & FeiyuTech either don't say that they are fully compatible with the XS-10 but other sites say they do work ok but some functions don't. It's quite difficult to work out which functions work & which don't. Thanks.
    • jerryy
      Fall pictures

      By jerryy · Posted

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • DavidJohn
      A portrait with a 28mm lens

      By DavidJohn · Posted

      This was snapped during a lunch.  Total shooting time—a few seconds. We so often read that a proper "portrait" should be snapped with a longer than normal lens, a low ISO to get lots of detail, and have a soft light held up above the head, and slightly to the side. The key, in my opinion, is always carry a camera.  Have your camera available to capture candid, authentic photographs.  Available light, no posing.   This portrait used 2000 ISO, the lens wide open at f4, and 1/100 sec. to stop any movement.  I didn't even take time to compose—I just snapped.  I leave the "Face Detection" on unless I'm photographing a landscape or subject other than a person. The GFX100RF has the equivalent of a 28mm lens.  The large sensor renders fine detail even at fairly high ISO ratings.  And the drawing of the lens is just perfect in my opinion.  It was set to B & W, with slightly reduced sharpness and clarity (set in-camera).  Ideal for "portraits."  Now, for some subjects I will likely increase the sharpness and clarity to the normal setting.  The camera is new, and I'm still experimenting with it.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

    • jerryy
      Astro-photography (open thread)

      By jerryy · Posted

      Back on page three of this thread is an image and mention of those mythological and astronomical twins, Castor and Pollux. They are back for your viewing pleasure in the night sky with Jupiter joining them, an added bonus this year. At least for those stargazing in the Northern Hemisphere anyway. For right now, you will need to wait until late at night, Very Late. or Very Early in the morning if your clock works that way. A little after midnight. Look a little to the left of Orion and there these three will be forming an arc.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

      Procyon is along for the arc ride... As long as the clouds are not too much, the arc is visible even in cloudy, light polluted skies like the one shown here. This is the equivalent of a just almost but not quite ten minutes stars exposure with a five seconds clouds exposure.  
×
×
  • Create New...