Jump to content

X-T4 Interval shooting Freeze with firmware 1.25 and 1.30


Recommended Posts

I purchased my X-T4 last month and i do alot of timelapse. My camera came with the 1.25 firmware and it froze multiple times during interval shooting. I searched online and some said it was due to bluetooth sync, so i checked my setup and my bluetooth was off, i never sync it with any phone or computer, never connect it online neither. When firmware 1.30 was released i thought it would fix the problem but i didn't. From my experience, the chances of crashing is higher when i set a small time interval (less than 5 seconds), and the problem is especially prominent between 3-4 s interval. I don't think it is due to overheating. 

I'm using a Kingston Canvas React Plus SD card.

I'm a fuji fan but i'm really disappointed with this X-T4 issue.

Edited by JinRoh
Link to post
Share on other sites

  • 4 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Similar Content

  • Posts

    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • Anyone out there have any experience/feedback on the Laowa 55 mm tilt shift? I’d be using it on the GFX 50s ii. 
    • Hi, I'm researching a gimbal to get someone as a present & they use a Fuji XS-10. I did a quick search of previous threads on gimbals but all of them seem to either get no replies or spammed by a link to an Amazon list. I'd appreciate any comments from folks who've actually used specific gimbals with the XS-10. I'm aware that some, such as certain models from Zhiyun, DJI & FeiyuTech either don't say that they are fully compatible with the XS-10 but other sites say they do work ok but some functions don't. It's quite difficult to work out which functions work & which don't. Thanks.
    • Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

       
    • This was snapped during a lunch.  Total shooting time—a few seconds. We so often read that a proper "portrait" should be snapped with a longer than normal lens, a low ISO to get lots of detail, and have a soft light held up above the head, and slightly to the side. The key, in my opinion, is always carry a camera.  Have your camera available to capture candid, authentic photographs.  Available light, no posing.   This portrait used 2000 ISO, the lens wide open at f4, and 1/100 sec. to stop any movement.  I didn't even take time to compose—I just snapped.  I leave the "Face Detection" on unless I'm photographing a landscape or subject other than a person. The GFX100RF has the equivalent of a 28mm lens.  The large sensor renders fine detail even at fairly high ISO ratings.  And the drawing of the lens is just perfect in my opinion.  It was set to B & W, with slightly reduced sharpness and clarity (set in-camera).  Ideal for "portraits."  Now, for some subjects I will likely increase the sharpness and clarity to the normal setting.  The camera is new, and I'm still experimenting with it.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

×
×
  • Create New...