Peak Design anchor links

[Vedox]

Hi

I'm a newbie here i recently bought Fujifilm X-T10 and some lenses.

 

I'm former Nikon Dslr user so i had my favorite strap called Peak Design Slide i loved it because of its quick connecting system but its to wide to big for smaller Fuji and because i didn't find a buyer for my Slide strap to buy Peak Design anchor links or the Leash strap i cut the quick connecting system off the Slide strap off and attached it to fujifilm original strap.

 

Nothing new i know but today i maneged to get the anchor links thru the triangle intended hole of the Fuji camera because i hated howe it felt and locked Thur the triangle rings

 

I think this is the best solution for quick connect/disconnect strap

What do you think is there a better solution?

 

(I'm sorry for my bad english speling and stuff i'm from slovenia)

Welcome, dear visitor! As registered member you'd see an image here…

Simply register for free here – We are always happy to welcome new members!

[peterson1715]

You should remove the inserts in the strap holes because they will wear out the cord. Just push them out with a small screw driver or other small tool. They are there to prevent wear from the metal triangle links.

[Vedox]

Thank you i didnt see that will do

[rick.estrada]

I got these links a few weeks ago too but I could not get them into the lugs. How did you get them in there?

 

 

Sent from my iPad using Tapatalk

[Vedox]

I used a neeadle and a thread tied the anchor link cord and then pulled it slowly through the lugs, its hard to do but the result is muchh better and cleaner looking then if you put them through the triangle rings

[Vedox]

You also can use just the thread and tie it to the anchor link cord and then pull it thru the lugs