brianmilo

Third xpro2 and still getting this error. During a engagement session. Camera was in single shot mode 56 1.2 on I think. Wasn't doing anything speedy to over heat the camera.

my serial number is 61a07449 ordered another from b&h and getting a refund on the current one. Fuji USA support said they were unaware. Told me to shut it off for 24 hours without the battery to reset it. b&h said they were unaware of the problem as well.

Thanks for the update. Is LCE the place where you bought it? I am going to call fuji repair center today. I am in a bit of a pickle since I have another wedding this weekend, don't have much time to send it back and wait for another one to arrive.

I am in the same exact boat. I rolled the dice and kept shooting the xpro2 the rest of the day. I am ready to dump the canon just need to get this sorted out.

Yea I hear you, it happened at the start of the ceremony. I didn't want to but I had to sling the old 5d3 around the shoulder for a just in case on the precessional. Luckily no problems but it's not a good feeling to have that error come up so often at a wedding. I'll call support when they open tomorrow.

Last note on the issue I had, was using brand new sandisk extreme 128gb 95mbps cards.

This happened to me at least 10 times yesterday at a wedding while I was using it as my primary camera. Pretty scary... I used tried the shoot without lens on, happened with the 18 and 23 and fresh batteries. Looking for suggestions as well. I have another wedding next weekend and not sure exactly what I should do at this point.