Hi to everybody. A month ago I ordered from Aliexpress new lens called Kamlan f1.1. 50mm. It has come today, I was happy, it feet perfect. But unfortunately the shutter is not working with this lens. Is anybody advice me how to fix problem. Please, guys, help me. Thank you all in advance.
Hi, so I shoot mostly using the LCD, from the hip, and I encountered a program today with my XT1's. Somewhat similar to an old post: https://www.fuji-x-forum.com/topic/1948-x-t1-lcd-fails-when-articulated/
But my situation is a little different. When my LCD is completely flush, in the normal position against the body, it will be totally blacked out/looking like it's off. I've cycled the 'viewmode' and nothing has helped. I did a factory reset and updated the firmware. But I believe I have a body-to-LCD ribbon short.
If I pull the LCD away it will work, but only in a limited range. From angled slightly upwards to completely flat facing upwards to the sky. If it's totally parallel with the body to facing downs toward the ground, the LCD will black out/turn off. I can still take photos when it's like this though.
I'm pretty sure it's a short in the ribbon — if I push the ribbon around very gently, the screen will go on and off. But anyway, I would like to put this problem out there and see if anyone has encountered it before. The camera has seen a lot of use in the last 3 years, but no drops/damage. Luckily the EVF works normally and used XT1s are pretty cheap now.
I've been using my XH1 for a couple of weeks and have been shooting video. Recently when I shoot in F-Log I cant get the ISO below 800, it will let me choose a higher ISO but when I drop to 800 the ISO turns yellow and wont let me choose a lower setting. Am I being daft or have I clicked an auto setting by mistake I don't know about ? Any help or advise would be great.
Quite often, under artificial lights, the screen of both the LCD and the EVF of my Fuji XT20 is flickering/flashing quickly, making shooting unpleasant.
This video shows the issue: https://www.youtube.com/watch?v=MWk6i_udD34
When I turn the camera OFF, then ON again, there is an intense flickering at the beginning, but all flickering disappears after 1 second (but the issue might occur again a few minutes later).
The issue is present in both normal and high performance mode.
1) Does this happens to anyone else? I would also be interested to know if you don't experience this issue.
2) If it is caused by the reaction of the LCD/EVF to the fluorescent/LED lighting operating at a certain frequency, why is the issue temporary resolved by turning the camera OFF, then ON again?