Second post here would appreciate the input. I just purchased an X-T3 and X-H1.
The EVFs on paper are meant to be the same with same refresh rates when in boost mode.
The sizes are also meant to be almost exactly the same at 0.50 inches X-T3 and 0.48 inches X-H1 with the same resolution.
However the X-H1 EVF feels smaller (bigger black border around the edges) and not as clear. It also gives me eye strain after just a few minutes. (I have adjusted diopter). It feels like its further away if that makes sense?
Has anyone else noticed a difference between the EVFs when using them side by side because on paper they are meant to be the same. Perhaps its just this particular X-H1.
Just purchased an X-H1 (long time X-pro2 user) - seems a very nice camera. It seems the processor is a bit slower than my pro2. Software is 2.13.
Question, is there any way around EVF blackout (besides at CH @ 11fps?) Its really distracting. My Pro2 does not do this at all.
Hello there! I am a new buyer on Fujifilm. I own the X-S10 5 days.
I shoot compressed and uncompressed stills.
I have adjust setting for wired connection and set menu to USB CARD READER.
When i open the Fujifilm file on my PC i can see only JPGs and not my RAW FILES. I use a Sandisk SDXC extreme pro 64GB, UHS - 1, U-3, V-30 memory card.
(I used a card reader too. I can view only jpgs too. See the foto below).
Am i doing something wrong?
The camera body is updated to 2.10.
I bought a new Fuji X-T3 and went to take some pictures, JPG + RAF. I used two SIM cards (one as a backup). When I got back home, I started uploading all of them to my computer (Mac). I removed the main SIM card from the camera and plugged it into a multi/card reader, the same way I always do. There were in total: RAF = 147 photos, and JPG = 159 photos. I was able to upload: RAF = 75 photos (51%), and JPG = 117 photos (74%). After those photos were uploaded, an error message appeared in the screen: THE FINDER CAN’T COMPLETE THE OPERATION BECAUSE SOME DATA IN (NAME OF THE NEXT PICTURE) CAN’T BE READ OR WRITTEN. ERROR CODE -36. No more photos were uploaded, even when I tried several times. I also tried doing the process one photo at a time, and also repeated the process with the second SIM card. Same results.
Thinking that the two SIM cards were corrupted or damaged at the same time (???), I then tried to format and take some more pictures with another SIM card and to upload them to the computer. The same situation and exact message came up over. I am able to see all the pictures (RAF & JPG) directly from the SIM cards connected to the Mac, I just can’t upload them to it. My frustration is that 51% of the RAF, and 74% of the JPG photos were already uploaded using the same method, devices, computer, etc., without any problem, and then just stopped.
What can I do or check for? Is that something to do with the way the camera store the photos in the SIM card? Again, it performed as expected PARTIALLY, and then stopped!
Thank you for your advise.