Jump to content

Fuji XT2 and SmallHD 502 monitor - no signal


tjedrasik007

Recommended Posts

Hi everyone,

 

I recently switched from Sony to Fuji and I love it. The issue I'm having is I am unable to setup my SmallHD 502 monitor to connect to my X-T2. I was wondering if anyone else had an issue. I tried different cables, made sure all the firmware are up to date but still no success. I just get a message No Signal. I know that Atomos works but it is a 7inch monitor and I don't need the recording part yet...

 

This is a 5inch monitor with Vectorscope, Peaking, Waveforms and LUT support..

 

I contacted SmallHD but got a simple not supported answer, which a bit disappointing: 

 

From: Tiffany L Brantner
Sent: 11/26/2016
Subject: Fuji X-T2 and SmallHD 502

Thomasz,

We have heard from maybe 2 other people having the same issue. Until we can test the configuration, we cannot confirm it. But, at this point it seems that the monitor is not compatible with your camera.

Thanks,
Tiffany Brantner
SmallHD Customer Support and Sales
919-502-7125 (direct line)
919-439-2166 (main line:

 

I was wondering if anyone had success with this monitor and X-T2?

 

thank you

Tom

 

Link to post
Share on other sites

  • 6 months later...
  • 3 years later...
  • 9 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

  • Posts

    • Looking more like the next Fuji camera we see will be an X-T50 but it is still a rumor and no specs have been published.
    • Hey guys, The shutter on/off button switch may be loose on mine. After turning camera on and pressing the shutter/holding close to the area, the camera will turn off and say 'sensor cleaning'. This doesn't happen if I'm shooting via touch screen at all. Everything else is functional. Anyone else experience this before? Would love a much cheaper fix since Fuji Canada just quoted me $700 CAD to fix it, and considering everything else is functional except that part I'm not even sure why MPMB Main Board parts is being replaced😕 I got no explanation from them either.
    • As far as I know the firmware is not country specific. Are you sure that the filename has not been changed ( I am told this can happen with mac os). That's the only thing I can think of.
    • My x-t5 does not exhibit the focusing switch behaviour as you report it, so that is very strange and indicative of a fault. It does not matter whether the flash is attached or not. Once you set the camera for your studio flash, say 1/250th at f5.6, the camera, which is showing you what you will get at that exposure without the flash, will show a black screen unless the ambient light is brighter than what you would typically get indoors. That is why, as Jerry says, you have to set preview exp/wb to off. I have set a button for this.
    • I connected to FRAME.IO a while back and it works fine, but the camera wouldn't connect to the internet all of a sudden today and would get stuck on the reset screen, including initializing and even switching USB Connection mode. Is anyone else experiencing the same thing?
×
×
  • Create New...