Jump to content

Multi flash mode YN560-TX II not working?


Recommended Posts

Hello,

just reading at the manual, I found out that my Yongnuo YN560-TXII controller, is supporting "Multi Flash Frequency & Flash count". Strobo flash photography is a new technique to me, so I wanted to have a go to learn something new.
I then mounted it on top of my X-T3 and tried to do some strobo Off Camera Flash with it, paired with a YN660 speedlite, without success. When the flash gets triggered by the controller, it flashes only once.
When I press the "test" button on the speedlite it works correctly.
When I mount the speedlite directly on the camera hotshoe, the multi mode works correctly.

Is there anything I am missing or the multimode won't work through a controller (despite being available)?

Thank you.

Link to post
Share on other sites

  • 2 weeks later...

What are the flash settings in the camera? Is the YN660 set to Master or Slave?

In order to make strobo exposures, the camera needs to know to open the shutter and when to do so. It sounds like the speedlite is communicating with the camera when directly mounted, but your controller may not be. I assume you are triggering by radio transmission. Have you tried to trigger with the EF-X8? You will need to set the speedlite to Slave. This will verify the camera at least speaks "Yonguo". Perhaps the camera and trigger are in conflict at some level.     

Link to post
Share on other sites

  • 2 years later...

I have same issue on XT1. have Yn560iv on camera. 1 second exposure flash fired once. same case with Yn560Tx controller.

but on test button multi is firing perfectly. 

wondering what is missing in my camera setup. 

 

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

  • Posts

    • Looking more like the next Fuji camera we see will be an X-T50 but it is still a rumor and no specs have been published.
    • Hey guys, The shutter on/off button switch may be loose on mine. After turning camera on and pressing the shutter/holding close to the area, the camera will turn off and say 'sensor cleaning'. This doesn't happen if I'm shooting via touch screen at all. Everything else is functional. Anyone else experience this before? Would love a much cheaper fix since Fuji Canada just quoted me $700 CAD to fix it, and considering everything else is functional except that part I'm not even sure why MPMB Main Board parts is being replaced😕 I got no explanation from them either.
    • As far as I know the firmware is not country specific. Are you sure that the filename has not been changed ( I am told this can happen with mac os). That's the only thing I can think of.
    • My x-t5 does not exhibit the focusing switch behaviour as you report it, so that is very strange and indicative of a fault. It does not matter whether the flash is attached or not. Once you set the camera for your studio flash, say 1/250th at f5.6, the camera, which is showing you what you will get at that exposure without the flash, will show a black screen unless the ambient light is brighter than what you would typically get indoors. That is why, as Jerry says, you have to set preview exp/wb to off. I have set a button for this.
    • I connected to FRAME.IO a while back and it works fine, but the camera wouldn't connect to the internet all of a sudden today and would get stuck on the reset screen, including initializing and even switching USB Connection mode. Is anyone else experiencing the same thing?
×
×
  • Create New...