Jump to content

Recommended Posts

https://www.youtube.com/watch?v=C7zqJTzlSu0

https://youtu.be/Bg1HrHVikiQ?t=319
And Sony's latest debacle.

The only photography channel I trust, has never lied about recommendations, or camera lenses and other camera accessories; Proclaims that Sandisk is the only card that people should use.  However, they are sticking to the slow, and useless V30, (useless) instead of making a V90 SDXC card for the XT-4.  Not saying it is a bad card, or bad card company, just not good enough for 4K with 400mbps video that the XT-4 can produce.

The petition is this:  Work with Sandisk so they can give full quality SDXC cards for video use.  By that I mean V90 Sandisk SDXC cards.  People are paying big money for the junk V90 SDXC cards.  With the amount of money they are paying for the XT-4, they should get the full quality.  Not half the quality they pay for.
 

 

Link to post
Share on other sites

3 hours ago, Pierre said:

I use Lexar since the launch of X-T1 in 2014. I also use other UHS-II cards : Fujifilm, Sandisk, Sony  and Toshiba. I never had any issue with all these brands.

Thanks, good to have as many points of view as possible.

Link to post
Share on other sites

  • 3 weeks later...

I'd suggest doing your research before complaining about this. The V speed rating is relatively new and Sandisk has not refreshed their UHS-II offerings since the V spec was released.

Sandisk's V30 cards are their latest UHS-I cards, and that is the highest rating that can be applied to UHS-1 cards. These are actually capable of almost V90 performance (measured sustained sequential writes of over 85MB/s) and would have been rated as V60 cards if that rating was available for UHS-1 cards (which are artificially limited to V30 as a max rating despite the top UHS-1 cards delivering performance that essentially matches the V90 requirements)

Sandisk's UHS-II cards all qualify for the highest speed ratings available at the time of their introduction. However testing on sequential write shows sustained write performance of over 240MB/s, some two and a half times better than a V90 spec would require.

https://www.cameramemoryspeed.com/reviews/sd-cards/sandisk-extreme-pro-300-mbs-uhs-ii-128gb-sdxc-memory-card/#:~:text=II card reader.-,Performance,fast for an SD card.

Note if you compare performance, only one V90 rated card has faster sustained write performance than the Sandisk Extreme Pro UHS-II cards, and it's the Sony Tough card that's middle of the pack in terms of the top performers (most of which are not V90 rated). The fastest sustained write cards on the market are not V90 rated because the spec is too new)

So, in summary a quick check of actual performance would show you that Sandisk's top performance UHS-II cards had exceeded V90 spec before that spec existed. You should be using UHS-II cards for maximum performance in a X-T4 body.

Edited by mawz
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

  • Posts

    • Somehow my shutter fell off my X-a5. On Amazon, there are a number of camera shutter buttons for Fuji cameras. My first thought was that I could just purchase one of these and be ready to go. But after checking these out, it appears that these shutter buttons are for cameras with a screw hole in the shutter button and the X-a5 doesn't have this kind of shutter and even if it did, the shutter is gone.  I called Fuji and they wouldn't even discuss it or accept my photo above to view it, they said I had to send it in which I'm not ready to do. One more update... I just stuck a pin through the center opening of the small center hole and the shutter activated and took a picture. Seems like there could possibly be something to attach there, like a replacement release to remedy this. Based of my explanation and what you can see on this scan, can someone advise me what I need to purchase or what I need to do to resolve this? Thank you.

      Welcome, dear visitor! As registered member you'd see an image here…

      Simply register for free here – We are always happy to welcome new members!

    • Dear Fujifilm team,im a satisfied user of the Fujifilm X-S10 a compact but powerful camera that i appreciate very much. However , I would like to propose a firmware update that i believe would be greatly appreciate by many users Introduction the " Pixel shift-multi-shot " and Unlocking video recording in 4k/60p with 1.2 crop . Thanks for your attention,greeting from a passionate FujiLover 🙏🙂😌🌺❤️  
    • Yes Is some small amount leftover from the spot i cleaned. Inside only very less point of dust,yes my be are from manufacture Is very microscopic. anyway on pictures i not see dust and i not see the spot i clean. thankyou so much for your reply Is beautiful im Happy.Have a good day
    • Are you certain the spot is on the inside and not some small amount leftover from the spot you cleaned? Maybe try a different brand of lens cleaner, but make sure it is safe for lenses so that the lens coatings are not removed. Even weather resistant lenses can get dust inside, the seals can only keep out so much dust and zoom lenses are known to get dusty on occasion. More so than prime lenses do. Weather resistant means more sealing, but achieving perfect sealing is tough to get. It is also possible the dust has been there from the time it was manufactured and you are only now noticing because of the white dot. Does the dust show up in any of your photos? As far as cleaning cost goes, your local camera repair shop will be able to give you some estimates, prices will be different depending on where you are.
×
×
  • Create New...