Jump to content

Can't figure out why pictures are not crisp


AlexT

Recommended Posts

Hi,

I'm new to the Fuji system and bought a used XT-2 abd a brand new XF 18-135mm lens. Just went on my first trip with it and I'm not happy with how a lot of the pictures turned out. I can't understand why some of them look blurred (as in by movement). Some others just don't look crisp enough.

I'm attaching cropped versions at 100% zoom of the pictures to highlight some problem areas (they are not near the edges).

Perhaps I'm missing something, but I want to rule out my equipment being defective. Is this normal?

Picture1:

  • ISO-200
  • f/5.3
  • 1/1100sec
  • 74mm
  • OIS on

Picture2:

  • ISO-200
  • f/5.6
  • 1/640sec
  • 135mm
  • OIS on

Picture3:

  • ISO-200
  • f/5.6
  • 1/1000sec
  • 88mm
  • OIS on

Welcome, dear visitor! As registered member you'd see an image here…

Simply register for free here – We are always happy to welcome new members!

Link to post
Share on other sites

These images could not be sharp for a number of reasons. There is an easy way to check. Find a room with plenty of light, no wind, and put camera on tripod. Get one of those charts with lots of lines and colours - like a projector focussing chart - and take pictures (using a cable release or self timer) of it at various distances and apertures. Then you will know.

Link to post
Share on other sites

On 2/8/2020 at 1:41 AM, Chas said:

These images could not be sharp for a number of reasons. There is an easy way to check. Find a room with plenty of light, no wind, and put camera on tripod. Get one of those charts with lots of lines and colours - like a projector focussing chart - and take pictures (using a cable release or self timer) of it at various distances and apertures. Then you will know.

What Chas said. It's impossible to objectively determine how 'sharp' a lens is while you're shooting hand held. I don't think even a monopod was used to take those pictures.

Even if a photographer doesn't have a proper chart, objective assessments can be made taking pictures of a brick wall (including barrel/pincushion distortion found in some zoom lenses).

Link to post
Share on other sites

It's also worth mentioning that, of the fuji lenses out there, this is one of the few that is kind of known for not being super-sharp in general ..... and you have quite a huge number of elements in motion here on top of that with lots of areas that would compete for focus ..... so like the guys above said, first things first, do an objective test of the camera and lens at the focal lengths and aperture that you're describing with everything else out of the picture to determine if your combination is going to produce what end result with every other variable accounted for. 

Link to post
Share on other sites

On 2/7/2020 at 9:38 AM, AlexT said:

I was not really moving myself, and at the shutter speeds I'm using it shouldn't matter either? 

I'm using AF-S, with single point focus. 

No matter what shutter speed you use, if you are inducing camera shake, the image will be blurry.  Up close you can see movement from left to right in some parts of the image.  As others have suggested, take some photos on a tripod and compare the results.

Link to post
Share on other sites

What camera have you upgraded from? Bear in mind that a 24mpx pic will look a lot less sharp than a 16 or 12 Mpx pic when both are viewed at 100%. To me the first two don’t look too bad for handheld pics, at 100% you’re looking at part of an image which would be over 30” across, which you wouldn’t normally view nearly as close up. 
The third pic looks like it has some movement for sure. 

Link to post
Share on other sites

On 2/7/2020 at 4:38 PM, AlexT said:

I was not really moving myself, and at the shutter speeds I'm using it shouldn't matter either? 

I'm using AF-S, with single point focus. 

AF-s focussing is best for not moving objects.

AF-c is best used for moving objects, it keeps on focusing with every movement of the subject or the photographer, like the boat moving or the water falling from the rock.

Regards, Roeland, x-t20

Link to post
Share on other sites

I agree that your shutter speeds should have eliminated any blur from camera shake at those focal lengths.  However, it looks like your auto focus just missed a bit, and you probably should have stopped down to f/8 for both deeper depth of field and I suspect that your lens is probably sharper at f/8 as well.  Finally, I wouldn't use AF-S for a moving subject unless it is only lateral movement that wouldn't change the distance between you and the subject.  

Link to post
Share on other sites

11 hours ago, Geno said:

I agree that your shutter speeds should have eliminated any blur from camera shake at those focal lengths.  However, it looks like your auto focus just missed a bit, and you probably should have stopped down to f/8 for both deeper depth of field and I suspect that your lens is probably sharper at f/8 as well.  Finally, I wouldn't use AF-S for a moving subject unless it is only lateral movement that wouldn't change the distance between you and the subject.  

Just a quick calculation.
At f 5.6, with a subject at 300ft, you get focus from 105ft to infinity.

At f8, you get focus from 85ft to infinity.

It would have had to be a serious focus error for it being a depth of field problem.

Link to post
Share on other sites

9 hours ago, flamidey said:

Just a quick calculation.
At f 5.6, with a subject at 300ft, you get focus from 105ft to infinity.

At f8, you get focus from 85ft to infinity.

It would have had to be a serious focus error for it being a depth of field problem.

Thanks for your contribution toward helping the OP figure out his problem.  Maybe he wasn't an entire football field away from his subjects.  It doesn't look like it unless he did some very extensive cropping.  Regardless, most consumer zooms that cover that large a focal length range generally aren't their sharpest when shot wide open, and it looks like he was probably either wide open or close to wide open on those shots. 

Edited by Geno
typo correction
Link to post
Share on other sites

Hi everyone, thanks for all the valuable input. I have contacted Fuji support and hopefully will be doing some tests with them this week to figure out if there's something wrong with the lens or not. Will post an update if they manage to get the same lens as a sample to use this week!

Link to post
Share on other sites

19 hours ago, Geno said:

Thanks for your contribution toward helping the OP figure out his problem.  Maybe he wasn't an entire football field away from his subjects.  It doesn't look like it unless he did some very extensive cropping.  Regardless, most consumer zooms that cover that large a focal length range generally aren't their sharpest when shot wide open, and it looks like he was probably either wide open or close to wide open on those shots. 

Well, even if we assume it was a 100 ft distance, he'd still get over 100ft DoF. I agree the 18-135 is better stopped down but not to the point of having an 88mm f5/6 shot completely blurry like that.

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

  • Posts

    • Looking more like the next Fuji camera we see will be an X-T50 but it is still a rumor and no specs have been published.
    • Hey guys, The shutter on/off button switch may be loose on mine. After turning camera on and pressing the shutter/holding close to the area, the camera will turn off and say 'sensor cleaning'. This doesn't happen if I'm shooting via touch screen at all. Everything else is functional. Anyone else experience this before? Would love a much cheaper fix since Fuji Canada just quoted me $700 CAD to fix it, and considering everything else is functional except that part I'm not even sure why MPMB Main Board parts is being replaced😕 I got no explanation from them either.
    • As far as I know the firmware is not country specific. Are you sure that the filename has not been changed ( I am told this can happen with mac os). That's the only thing I can think of.
    • My x-t5 does not exhibit the focusing switch behaviour as you report it, so that is very strange and indicative of a fault. It does not matter whether the flash is attached or not. Once you set the camera for your studio flash, say 1/250th at f5.6, the camera, which is showing you what you will get at that exposure without the flash, will show a black screen unless the ambient light is brighter than what you would typically get indoors. That is why, as Jerry says, you have to set preview exp/wb to off. I have set a button for this.
    • I connected to FRAME.IO a while back and it works fine, but the camera wouldn't connect to the internet all of a sudden today and would get stuck on the reset screen, including initializing and even switching USB Connection mode. Is anyone else experiencing the same thing?
×
×
  • Create New...