Global Otter

K, I appreciate your assistance. I'm still having issue with getting the shutter speed warning to go away on the Fuji X-T3 Movie Mode menu. I have tried increasing the shutter speed, that had been 60, in the electronic menu and on the manual wheel on the top of the camera to 60, 120, 240. The message: “Cannot Use S.S. Slower Than Framerate” remains at the bottom of the Movie Mode menu. It will not go away unless I lower the resolution to FHD 16:9. Even at 4k 16:9 the the message reappears. Is there a trick to changing Shutter Speed that I'm missing on the X-T3. Again the output is by HDMI to an Atomos Ninja V. I really need 59.94p DCI 17:9 (4096 x 2160) 400Mbps with ALL-I in order to produce competitive B-Roll slow motion macro clips. I can't compromise on this level of output quality. Thank you, Terrence

Jerry, Thank you for the assistance! Terrence

Did you ever figure this out?

BTW, the manual states, "When 4K is 59.94P and 50P automatically switch to 29.97P and 25P, respectively." So, does the X-T3 not do any DCI 17:9 (4096 x 2160) output to the Ninja V at 59.94p? Just need to know so I can move on.

What does message: “Cannot Use S.S. Slower Than Framerate” mean. I'm trying to shot 59.94p DCI 17:9 (4096 x 2160) 400Mbps with ALL-I on my X-T3 with output to a Ninja V via HDMI. I don't want interpolated frames added. Just clean HDMI output to my Ninja V recorder. I need 59.94p slow motion. Can I do this or not? Should I ignore the message? Doing short 5 sec to 1 minute clips. Thank you,

Can I record to internal SD or SDXCII cards in the X-T3 as 10bit 4k 60p? If not, what are some possible ways to do so externally? New to the X-T3 and need very specific direction. Don't need an external monitor, but am willing to connect an HDMI from camera to a recorder. Would prefer to avoid the recorder and keep internal. If recorder is required, what is the basic setup? What recorder? Can I connect to a SSD Samsung T5s? Seeking practical advice? Want to keep rigs simple. I also use the BMPCC 6k and don't need to go external in the configuration I've been using. This is needed for planned slow-motion clips. Balance of filming is in 10 bit 4k 23.**fps. Thanks!!🙂